一、產品名稱:排氣管修補膠( Exhaust Pipe Repair Kit)
二、產品介紹:(Product Attribute)
排氣管修補密封膠是一款耐高溫型修補劑。本品安全而有效地密封及修補汽車排氣管、橡膠墊處理、消聲器、催化轉化器的破損或滲漏處,耐高溫至1100度,是裝配、更換或修補排氣管、消聲器、催化轉化器的較佳輔助用品。
(Exhaust System Sealer used for leaks in mufflers,tailpipes and around joints. Saves the cost of expensive muffler system replacement. Repairs will outlast muffler. Also makes new installation more secure. Sets like a weld, remarkable adhesion to clean or rusted surfaces. Resistant to monoxide gases and high temperatures.)
包裝:1 x 150g鋁管裝排氣管修補膠
凈重:150g
規格:12支/中盒,12中盒/箱
外箱尺寸:45.0*26.5*43.0cm
三、產品特點:(Advantage & Features)
外觀: 灰色/黑色/白色
易燃性: 無
耐溫度: 2500oF連續,(1100℃)
固化時間: 2-4個小時。
完全固化時間: 24小時。
具有很強的耐水和耐化學溶劑穩定性
l Saves Energy
l Applies Easily
l Stops Air Leaks
l Sets Rock Hard When Heated
l Super Tough, High Temperature Mortar
四、使用方式:(How to use it)
1. 開始維修之前,冷卻排氣管道系統至常溫;
2. 徹底清潔所有表面的油脂、油、油漆的痕跡、灰塵等;
3. 均勻地涂抹高溫排氣管修補密封膠到受損的物件表面;
4. 如果物件表面縫隙大于1厘米,需要配合金屬絲網使用;
5. 如果由于固化過快引起表面起泡,應該刮去起泡材料重新粘結修補。
Precautions
1. Surfaces must be clean, dry and free of dirt, grease or oil.
2. Wet the surface to be repaired with water.
3. Apply the Sealer directly over the hole.
4. Allow to dry for 30 minutes and start engine to run for at least 10 minutes.
5. For new installations, apply the Gum around inside of the larger pipe. Complete and seal the connection.
6. Clear up with water prior to material drying.
五、注意事項:
此產品不應該在純氧和/或富氧系統中使用,不能用于氯氣或其它強氧化性伴侶。
六、儲存方式:
儲存在陰涼,干燥的環境中,在未開封的容器中。